JD Backhoe Links, Pins & Bushings 310E-310SK

Replacement links, pivot pins, and bushings for John Deere 310 series backhoe loaders, covering boom, dipper, bucket, and swing linkage points across the E through K generations. New and used components rebuild worn pin bores and restore tight joint tolerances.

Fits Models At A Glance

• 310E/G Series: 310E, 310G, 310SE, 310SG
• 310J Series: 310J, 310SJ
• 310K Series: 310K, 310SK

Key Notes

• Application: Boom, dipperstick, bucket, and swing tower linkage joints
• Components: Connecting links, pivot pins, hardened bushings, and thrust washers
• Fitment: Confirm pin diameter and length against your machine before ordering
• Condition: New aftermarket and inspected used options available

Why Choose Broken Tractor

• ✅ Deep John Deere backhoe parts inventory ready to ship
• ✅ Knowledgeable staff verifies fitment before purchase
• ✅ Fast shipping from two US locations

Frequently Asked Questions

What John Deere backhoe models do these links, pins and bushings fit?

Broken Tractor carries links, pivot pins, and bushings covering the John Deere 310 series across the E through K generations. This includes the 310E, 310G, 310SE, 310SG, 310J, 310SJ, 310K, and 310SK. Confirm pin diameter and length against your machine before ordering since fitment can vary.

Where are these pins and bushings used on a John Deere 310 backhoe?

These components fit the boom, dipperstick, bucket, and swing tower linkage joints on 310 series backhoe loaders. We carry connecting links, pivot pins, hardened bushings, and thrust washers for these points. Match the specific joint you are rebuilding to the correct pin diameter and length.

How do I know if my 310 backhoe pins and bushings are worn out?

Worn pins and bushings usually show up as sloppy or loose linkage joints, excess play at the boom, dipper, or bucket, and clunking under load. Replacing worn pins along with the hardened bushings restores tight joint tolerances. We offer new aftermarket and inspected used components to rebuild these joints.

Do I need to replace both the pin and the bushing together?

It is best to replace the pin and bushing as a set because a worn pin will quickly wear a new bushing and the reverse is also true. Broken Tractor carries matching pivot pins, hardened bushings, and thrust washers for the 310 series linkage joints. Confirm the pin diameter and length for your specific joint before ordering.

How do I confirm the right pin size for my 310E to 310SK backhoe?

Measure the pin diameter and length and match them against the part you are ordering, since fitment can differ by joint and generation across the 310E through 310SK range. Our staff verifies fitment before purchase, so you can confirm the correct part by calling (800) 909-7060. This helps avoid ordering a pin that does not match your machine.