King Kutter Post Hole Digger Parts

Replacement post hole digger parts for King Kutter PHD units, covering main frame poles, lift arm A-frames, gearbox weldments, augers, PTO drive shafts, and hardware for 6", 9", and 12" auger setups.

Fits Models At A Glance

• PHD Series: King Kutter Post Hole Diggers
• Auger Sizes: 6", 9", 12"

Key Notes

• Structural Parts: Main frame poles, lift arm A-frames, and gearbox and collar weldments
• Drivetrain: PTO drive shafts with slip clutch and grease fitting sets
• Auger Components: Auger assemblies, auger points, cutting edge kits, and bronze stop washers
• Hardware: Pin sets, latch bases, top gearbox bolts, and protective shields

Why Choose Broken Tractor

• ✅ Correct fitment for King Kutter PHD units
• ✅ Fast shipping from two US locations
• ✅ Knowledgeable support for post hole digger parts

Frequently Asked Questions

What auger sizes do King Kutter post hole digger parts fit?

Broken Tractor carries parts for King Kutter PHD units set up for 6", 9", and 12" augers. Items like the Top Gearbox Bolt (SKU 184095) are listed for all three auger sizes. Match the part number to your unit or confirm the correct auger size with our parts team.

How do I replace a worn auger point on a King Kutter post hole digger?

We offer the Auger Point for King Kutter Post Hole Digger (SKU 177050) as a direct replacement for a dulled or worn point. For augers with worn blades, Broken Tractor also carries the Cutting Edge Kit (SKU 570104-570102). Replacing these worn wear parts restores boring performance without buying a whole new auger assembly.

What is included in a King Kutter PTO drive shaft for a post hole digger?

Broken Tractor carries the King Kutter PTO Drive Shaft with Slip Clutch (SKU 147146) for post hole diggers. We also offer a separate PTO Drive Shaft Grease Fitting Set (SKU 132017) for maintaining the shaft. Confirm the part number matches your PHD unit before ordering.

Which structural parts can I replace on a King Kutter post hole digger frame?

We carry the Main Frame Pole (SKU 404290), the Lift Arm A-Frame (SKU 404291), and the Gearbox and Collar Weldment (SKU 404292) for King Kutter PHD units. These cover the main structural weldments if a pole or A-frame is bent or damaged. Match the part number to your unit or check with our parts team to confirm fitment.

Do you sell the gearbox shield and hardware for a King Kutter post hole digger?

Yes, Broken Tractor carries the Gearbox Protective Shield (SKU 570100), Pin Set (SKU 570101), Latch Base (SKU 570105), and the Bronze Auger Stop Washer (SKU 135081) for King Kutter post hole diggers. These smaller hardware and protective parts are commonly replaced during service. Call (800) 909-7060 if you need help identifying the right part for your PHD unit.