John Deere Lower Pull Arm Front Half, Left Hand, 3-Point Hitch - AL26678

Fits Models At A Glance:

John Deere Tractors:

• 940, 1040, 1120, 1130, 1140, 1550, 1640, 1750, 1840, 1850, 1950, 2030, 2040, 2040S, 2130, 2140, 2240 After Serial Number 350000, 2250, 2350, 2355, 2440 After Serial Number 341000, 2450, 2550, 2555, 2640 After Serial Number 341000, 2650, 2750, 2755, 2850, 2855, 301A

John Deere Backhoe Loaders:

• 300B, 401B, 401C

John Deere Industrial & Construction:

• 302, 302A, 401D

Common Use Case or Symptoms:

Use when the draft link is bent, the ball end is egg-shaped, or the arm will not line up with the implement pin — a sprung pull arm puts the whole three-point out of square and wears the implement mounts.

Key Notes:

• Part Numbers: AL26678, 111977
• Weight: 26.38 lbs
• Application: Three-point hitch lower draft link, front half
• Side Fitment: Left hand. The right-hand mate is AL26679.
• Serial Number Notes: 2240 fits After Serial Number 350000. 2440 and 2640 fit After Serial Number 341000.
• Manufacturer: A & I Products
• Replacement Part for John Deere Equipment

Why Choose Broken Tractor:

• ✅ Front Half Only, Sold Separately: The rear half is AL24137 — if only the front is bent you replace only the front, which is most of the cost of a full arm saved.
• ✅ Left and Right Both Stocked: AL26678 is the left; AL26679 is the right. Order the pair and the hitch sits square again.
• ✅ Thirty-Seven Machines Covered: One arm spans the 940 through 2855 utility tractors plus the 300B and 401 backhoes.