Serial Number Location
The serial number is stamped on a plate located on the right side of the transmission housing, just behind the engine block. For Red Demonstrators, serial numbers typically fall within the #99356 to ~106000 range (early 1950).
Key Specifications
| Feature |
Specification |
| Year Produced |
1950 (Demonstrator Series) |
| Engine Model |
IH C60, 4-cylinder gasoline |
| Displacement |
59.5 cubic inches |
| Drawbar Horsepower |
9.25 HP |
| Belt PTO Horsepower |
10.25 HP |
| Transmission |
3-speed sliding gear manual |
| PTO Type |
Independent rear PTO |
| Wheelbase |
69.25 inches (1,759 mm) |
| Bare Tractor Weight |
1,477 lbs (670 kg) |
| Fuel Capacity |
7 quarts (1.75 gallons / 6.6 liters) |
Historical Significance
-
Factory White Paint: Though dubbed “Red Demonstrators,” these tractors were originally painted white to attract attention at shows and dealerships
-
Limited Production Run: Built early in 1950, they were often repainted Farmall Red before resale
-
Collector’s Model: Only a few thousand units were made, making original-condition tractors extremely rare and valuable
-
Promotional Use: Designed to showcase features of the Cub line to prospective buyers before transitioning back to regular production units
Key Features
-
Offset Cultivision Design: Provides clear visibility of the row for cultivating and tilling
-
Compact, Agile Build: Perfect for small farms, orchards, and tight plots
-
Fuel-Efficient Engine: C60 engine provides reliable power with low fuel use
-
Wide Implement Compatibility: Supports mowers, cultivators, plows, and mid-mount attachments
-
Vintage Collector Appeal: Especially rare in original white paint or with photographic documentation
Common Replacement Parts
Shop premium Farmall Cub Red Demonstrator parts at Broken Tractor:
Engine
-
Pistons, rings, gaskets, carburetors, valves, ignition tune-up kits
Transmission & Clutch
PTO & Final Drive
Cooling & Fuel
Steering & Electrical
-
Steering boxes, tie rods, magnetos, generators, lighting kits
Maintenance Tips
| Task |
Suggested Interval |
| Oil Change |
Every 100 hours or seasonally |
| Air Filter Service |
Monthly or after dusty conditions |
| Cooling System Check |
Monthly; flush every 2 years |
| Fuel System Cleanout |
Annually |
| Grease Fittings |
Weekly or before each use |