Case SV280B Skid Steer Loader – Parts, Specs

Description:

Serial Number Location

The serial number plate is located on the right-hand side of the loader arm or the main frame near the front hinge, just below the operator cab. Always verify this number before ordering parts to ensure correct fitment.

Key Specifications

• Model Years: 2025 – Present

• Engine: 6.7 L, 6-cylinder diesel, Tier 4 Final

• Net Power: 280 hp @ 2,400 rpm

• Operating Weight: 31,500 lb (with bucket and full fuel)

• Rated Operating Capacity: 17,000 lb

• Tipping Load: 34,000 lb

• Bucket Breakout Force: 50,000 lb

• Lift Height (to bucket hinge pin): 15 ft 6 in

• Loader Reach at Full Height: 4 ft 8 in

• Travel Speed: Up to 13 mph (two-speed)

• Ground Pressure: 14.5 psi

• Turning Radius (outside): 10 ft 2 in

• Length with Standard Bucket: 17 ft 2 in

• Width (with bucket): 7 ft 6 in

• Height to Cab Roof: 9 ft 0 in

• Fuel Tank Capacity: 62 gallons

• Hydraulic System Capacity: 62 gallons

• Auxiliary Hydraulic Flow: 62 gpm

• Hydraulic Operating Pressure: 5,200 psi

• Standard Bucket Capacity: 2.75 cubic yards

• Auxiliary Coupler: Universal quick‑attach standard

Performance & Design Highlights

• Extreme-Class Strength: 17,000 lb rated capacity and 50,000 lb breakout force for heavy lifting tasks

• Ultra-High-Flow Hydraulics: 62 gpm flow-sharing system supports demanding attachments and precise control

• Premium Cab Comfort: ROPS/FOPS-certified with air-ride suspension seat, HVAC, panoramic visibility, and rear camera-ready

• High-Speed Travel: Two-speed transmission for up to 13 mph travel; low gear for heavy-load cycles

• Attachment Versatility: Built for forks, grapples, mulchers, augers, sweepers, breakers, and snow tools

Routine Maintenance

• Engine Oil & Filter: Replace every 500 hours

• Hydraulic Fluid & Filter: Change every 1,000 hours; filter every 500 hours

• Fuel Filter: Replace every 500 hours

• Air Filter: Inspect every 250 hours; replace as needed

• Grease Points: Lubricate loader arms, pivot joints, and coupler daily

• Cooling System: Clean radiator and coolers weekly

• Tire or Track Inspection: Check before each operation for wear or correct pressure

Common Issues & Fixes

• Hydraulic Hose Wear: Inspect daily; replace worn or damaged hoses promptly to maintain performance

• Tire or Undercarriage Wear: Monitor tread and drive components; service or replace as needed

• Overheating: Keep cooling components clear of debris; maintain proper coolant levels

• Electrical or Sensor Alerts: Use onboard diagnostics to inspect wiring, fuses, and connectors when alerts appear

• Loss of Breakout Force: Replace worn bucket teeth and maintain clean hydraulic filters and fluid