Case SR270 Skid Steer Loader – Parts, Specs

Description:

Serial Number Location

The serial number plate is located on the right-hand side of the loader arm or frame near the front hinge, just below the operator cab. Always verify before ordering parts to ensure proper fit.

Key Specifications

• Model Years: 2025 – Present

• Engine: 6.7 L, 6‑cylinder diesel, Tier 4 Final

• Net Power: 270 hp @ 2,400 rpm

• Operating Weight: 30,000 lb (with bucket and full fuel)

• Rated Operating Capacity: 15,500 lb

• Tipping Load: 31,000 lb

• Bucket Breakout Force: 45,000 lb

• Lift Height (to bucket hinge pin): 15 ft 0 in

• Loader Reach at Full Height: 4 ft 4 in

• Travel Speed: Up to 12 mph (two‑speed)

• Ground Pressure: 14.0 psi

• Turning Radius (outside): 10 ft 0 in

• Length with Standard Bucket: 16 ft 8 in

• Width (with bucket): 7 ft 6 in

• Height to Cab Roof: 8 ft 10 in

• Fuel Tank Capacity: 58 gallons

• Hydraulic System Capacity: 58 gallons

• Auxiliary Hydraulic Flow: 58 gpm

• Hydraulic Operating Pressure: 5,200 psi

• Standard Bucket Capacity: 2.50 cubic yards

• Auxiliary Coupler: Universal quick‑attach standard

Performance & Design Highlights

• Extreme-Class Strength: 15,500 lb rated capacity with 45,000 lb breakout force for handling large loads

• Ultra-High-Flow Hydraulics: Flow-sharing system supports demanding attachments and simultaneous steering control

• Premium Cab Features: ROPS/FOPS-certified with air-ride suspension seat, full HVAC, panoramic visibility, and rear camera-ready

• Efficient Site Mobility: Two-speed transmission up to 12 mph; low gear used for lift cycles

• Attachment Compatibility: Built to handle heavy-duty forks, grapples, sweepers, mulchers, breakers, and snow implements

Routine Maintenance

• Engine Oil & Filter: Replace every 500 hours

• Hydraulic Fluid & Filter: Change every 1,000 hours; filter every 500 hours

• Fuel Filter: Replace every 500 hours

• Air Filter: Inspect every 250 hours; replace as needed

• Grease Points: Daily lubrication of loader arms, pivot pins, and coupler

• Cooling System: Clean radiator and coolers weekly

• Tire or Track Inspection: Check before each use for wear and proper pressure

Common Issues & Fixes

• Hydraulic Hose Wear: Inspect daily; replace any showing signs of abrasion or leakage to prevent failure

• Tire or Undercarriage Wear: Monitor tread and structural integrity—service or replace promptly

• Overheating: Keep cooling system clear of debris; maintain coolant levels

• Electrical or Sensor Alerts: Use onboard diagnostics to inspect wiring, fuses, and connectors

• Decline in Breakout Force: Replace worn bucket teeth and maintain clean hydraulic filters and fluid