Case SR250 Skid Steer Loader – Parts, Specs

Serial Number Location

The serial number plate is located on the right-hand side of the loader arm or frame near the front hinge, just below the operator cab. Always verify it before ordering parts to ensure correct fit.

Key Specifications

• Model Years: 2025 – Present

• Engine: 6.7 L, 6-cylinder diesel, Tier 4 Final

• Net Power: 250 hp @ 2,400 rpm

• Operating Weight: 28,500 lb (with bucket and full fuel)

• Rated Operating Capacity: 14,000 lb

• Tipping Load: 28,000 lb

• Bucket Breakout Force: 42,000 lb

• Lift Height (to bucket hinge pin): 14 ft 6 in

• Loader Reach at Full Height: 4 ft 2 in

• Travel Speed: Up to 12 mph (two-speed)

• Ground Pressure: 13.0 psi

• Turning Radius (outside): 9 ft 10 in

• Length with Standard Bucket: 16 ft 4 in

• Width (with bucket): 7 ft 4 in

• Height to Cab Roof: 8 ft 8 in

• Fuel Tank Capacity: 55 gallons

• Hydraulic System Capacity: 55 gallons

• Auxiliary Hydraulic Flow: 55 gpm

• Hydraulic Operating Pressure: 5,000 psi

• Standard Bucket Capacity: 2.25 cubic yards

• Auxiliary Coupler: Universal quick‑attach included

Performance & Design Highlights

• Extreme-Class Performance: 14,000 lb rated capacity and 42,000 lb breakout force for the toughest material handling and loading tasks

• Ultra-High-Flow Hydraulics: Flow-sharing system ensures power and precision with heavy-duty attachments

• Premium Cab: ROPS/FOPS-certified, air-ride suspension seat, full HVAC, panoramic visibility, and rear camera-ready

• Efficient Mobility: Two-speed drive up to 12 mph for quick site transitions; low gear for load cycles

• Attachment Versatility: Suppports forks, grapples, augers, sweepers, breakers, snow tools, and mulchers

Routine Maintenance

• Engine Oil & Filter: Replace every 500 hours

• Hydraulic Fluid & Filter: Change every 1,000 hours; filter every 500 hours

• Fuel Filter: Replace every 500 hours

• Air Filter: Inspect every 250 hours; replace as needed

• Grease Points: Lubricate loader arms, pivot joints, and coupler daily

• Cooling System: Clean radiator and coolers weekly

• Tire or Track Inspection: Check pressure and wear before each use

Common Issues & Fixes

• Hydraulic Hose Wear: Inspect daily; replace any with signs of abrasion or leakage promptly

• Tire or Undercarriage Wear: Monitor tread condition and structural integrity; service or replace as necessary

• Overheating: Keep cooling system clean; ensure proper coolant levels

• Electrical or Sensor Alerts: Use onboard diagnostics to inspect wiring, fuses, and connections when fault codes appear

• Decline in Breakout Force: Replace worn bucket teeth and ensure hydraulic fluid and filters are clean