Case SR240B Skid Steer Loader – Parts, Specs

Description:

Serial Number Location

The serial number plate is located on the right-hand side of the loader arm or frame near the front hinge, just below the operator cab. Always verify before ordering parts to ensure correctness.

Key Specifications

• Model Years: 2025 – Present

• Engine: 6.7 L, 6‑cylinder diesel, Tier 4 Final

• Net Power: 240 hp @ 2,400 rpm

• Operating Weight: 27,200 lb (with bucket and full fuel)

• Rated Operating Capacity: 12,500 lb

• Tipping Load: 25,000 lb

• Bucket Breakout Force: 37,000 lb

• Lift Height (to bucket hinge pin): 14 ft 0 in

• Loader Reach at Full Height: 4 ft 0 in

• Travel Speed: Up to 12 mph (two‑speed)

• Ground Pressure: 12.8 psi

• Turning Radius (outside): 9 ft 8 in

• Length with Standard Bucket: 16 ft 0 in

• Width (with bucket): 7 ft 2 in

• Height to Cab Roof: 8 ft 6 in

• Fuel Tank Capacity: 52 gallons

• Hydraulic System Capacity: 52 gallons

• Auxiliary Hydraulic Flow: 52 gpm

• Hydraulic Operating Pressure: 4,800 psi

• Standard Bucket Capacity: 2.20 cubic yards

• Auxiliary Coupler: Universal quick‑attach standard

Performance & Design Highlights

• Ultra-Heavy-Class Strength: 12,500 lb rated capacity with 37,000 lb breakout force for top-tier lifting

• High-Flow Hydraulics: Flow-sharing system powers heavy-duty attachments while maintaining precise control

• Premium Cab Comfort: ROPS/FOPS-certified with air-ride suspension seat, automatic HVAC, and rear camera-ready

• Two-Speed Travel: Up to 12 mph travel speed; low gear mode for loaded lifting cycles

• Attachment Versatility: Designed for use with forks, grapples, mulchers, breakers, sweepers, and snow tools

Routine Maintenance

• Engine Oil & Filter: Replace every 500 hours

• Hydraulic Fluid & Filter: Change every 1,000 hours; filter every 500 hours

• Fuel Filter: Replace every 500 hours

• Air Filter: Inspect every 250 hours; replace as needed

• Grease Points: Daily lubrication on loader arms, pivot joints, and coupler

• Cooling System: Clean radiator and coolers weekly

• Tire or Track Inspection: Check before each operation for wear or correct pressure

Common Issues & Fixes

• Hydraulic Hose Wear: Inspect daily; replace any showing abrasion or leaks promptly

• Tire / Undercarriage Wear: Monitor tread and structural integrity; service or replace as needed

• Overheating: Maintain clear cooling systems and correct coolant levels

• Electrical or Sensor Alerts: Use onboard diagnostics to inspect wiring, connections, and fuses

• Decline in Breakout Force: Replace worn bucket teeth and ensure hydraulic system fluid and filters are clean