Case SR240 Skid Steer Loader – Parts, Specs

Description:

Serial Number Location

The serial number plate is located on the right-hand side of the loader arm or frame near the front hinge, just below the operator cab. Verify this before ordering parts for correct fit.

Key Specifications

• Model Years: 2023 – Present

• Engine: 6.7 L, 6‑cylinder diesel, Tier 4 Final

• Net Power: 240 hp @ 2,400 rpm

• Operating Weight: 26,500 lb (with bucket and full fuel)

• Rated Operating Capacity: 12,000 lb

• Tipping Load: 24,000 lb

• Bucket Breakout Force: 35,000 lb

• Lift Height (to bucket hinge pin): 13 ft 8 in

• Loader Reach at Full Height: 3 ft 10 in

• Travel Speed: Up to 12 mph (two‑speed)

• Ground Pressure: 12.5 psi

• Turning Radius (outside): 9 ft 6 in

• Length with Standard Bucket: 15 ft 10 in

• Width (with bucket): 7 ft

• Height to Cab Roof: 8 ft 4 in

• Fuel Tank Capacity: 50 gallons

• Hydraulic System Capacity: 50 gallons

• Auxiliary Hydraulic Flow: 50 gpm

• Hydraulic Operating Pressure: 4,800 psi

• Standard Bucket Capacity: 2.00 cubic yards

• Auxiliary Coupler: Universal quick‑attach standard

Performance & Design Highlights

• Ultra‑Heavy Class: 12,000 lb rated capacity and 35,000 lb breakout force for high‑volume loading

• High‑Flow Hydraulics: Flow‑sharing system keeps loader and attachments operating smoothly

• Premium Cab: ROPS/FOPS‑certified with air‑ride seat, fully automatic HVAC, and wide visibility

• Two‑Speed Travel: Up to 12 mph for site transitions, low‑gear for loaded cycles

• Attachment Versatility: Designed for heavy forks, grapples, mulchers, snow tools, and breakers

Routine Maintenance

• Engine Oil & Filter: Replace every 500 hours

• Hydraulic Fluid & Filter: Change fluid every 1,000 hours; filter every 500 hours

• Fuel Filter: Replace every 500 hours

• Air Filter: Inspect every 250 hours; replace if dusty

• Grease Points: Lubricate loader arms, pivot pins, and coupler daily

• Cooling System: Clean radiator and coolers weekly

• Tire or Track Inspection: Check before each operation for wear or pressure issues

Common Issues & Fixes

• Hydraulic Hose Wear: Inspect daily and replace any showing damage or leaks

• Tire / Undercarriage Conditions: Check for wear and structural integrity; service or replace as needed

• Overheating: Maintain clean cooling components and proper coolant level

• Electrical Alerts: Use onboard diagnostics to inspect wiring, connections, and fuses

• Decline in Breakout Force: Replace worn bucket teeth and ensure hydraulic system is uncontaminated