Case SR210B Skid Steer Loader – Parts, Specs

Description:

Serial Number Location

The serial number plate is located on the right-hand side of the loader arm or frame near the front hinge, just below the operator cab. Always verify it before ordering parts to ensure compatibility.

Key Specifications

• Model Years: 2025 – Present

• Engine: 6.7‑L, 6‑cylinder diesel, Tier 4 Final

• Net Power: 210 hp @ 2,400 rpm

• Operating Weight: 23,500 lb (with bucket and full fuel)

• Rated Operating Capacity: 10,800 lb

• Tipping Load: 21,600 lb

• Bucket Breakout Force: 31,000 lb

• Lift Height to Bucket Hinge Pin: 13 ft 6 in

• Loader Reach at Full Height: 3 ft 8 in

• Travel Speed: Up to 12 mph (two-speed)

• Ground Pressure: 11.8 psi

• Turning Radius (outside): 9 ft 4 in

• Length with Standard Bucket: 15 ft 5 in

• Width (with bucket): 6 ft 8 in

• Height to Cab Roof: 8 ft 2 in

• Fuel Tank Capacity: 48 gallons

• Hydraulic System Capacity: 47 gallons

• Auxiliary Hydraulic Flow: 47 gpm

• Hydraulic Operating Pressure: 4,600 psi

• Standard Bucket Capacity: 1.80 cubic yards

• Auxiliary Coupler: Universal quick‑attach included

Performance & Design Highlights

• Super-Heavy-Class Strength: 10,800 lb rated capacity and 31,000 lb breakout force for extreme loading jobs

• Premium Hydraulics: High-flow, flow-sharing system supports powerful attachments and smooth controls

• Spacious Cab: ROPS/FOPS-certified with air-ride suspension seat, full HVAC, panoramic visibility, and rear camera capability

• Fast and Efficient: Two-speed travel reaching up to 12 mph for site transitions; low gear for heavy loads

• Attachment Ready: Built to accommodate heavy-duty forks, grapples, augers, breakers, sweepers, and snow tools

Routine Maintenance

• Engine Oil & Filter: Replace every 500 hours

• Hydraulic Fluid & Filter: Change oil every 1,000 hours; replace filter every 500 hours

• Fuel Filter: Replace every 500 hours

• Air Filter: Inspect every 250 hours; replace if conditions warrant

• Grease Points: Lubricate loader arms, pivot pins, and coupler daily

• Cooling System: Clean radiator screens and coolers weekly

• Tire or Track Inspection: Check before each operation for wear and correct pressure

Common Issues & Fixes

• Hydraulic Hose Wear: Inspect daily; replace worn or damaged hoses to prevent performance loss

• Tire or Undercarriage Wear: Monitor tread and component integrity; service or replace as appropriate

• Overheating: Maintain clear radiator and coolers; monitor coolant level

• Diagnostic Alerts: Use onboard display to check wiring, fuses, and sensors when codes appear

• Reduced Breakout Force: Replace worn bucket teeth and ensure hydraulic fluid and filters are clean