Case SR200 Skid Steer Loader – Parts, Specs

Description:

Serial Number Location

The serial number plate is located on the right-hand side of the loader arm or frame near the front hinge, just below the operator cab. Always verify this number before ordering parts to ensure proper fit.

Key Specifications

• Model Years: 2024 – Present

• Engine: 4.5‑L, 4‑cylinder diesel, Tier 4 Final

• Net Power: 180 hp @ 2,400 rpm

• Operating Weight: 18,500 lb (with bucket and full fuel)

• Rated Operating Capacity: 7,000 lb

• Tipping Load: 14,000 lb

• Bucket Breakout Force: 20,000 lb

• Lift Height (to bucket hinge pin): 12 ft 6 in

• Loader Reach at Full Height: 3 ft 2 in

• Travel Speed: Up to 11 mph (two-speed)

• Ground Pressure: 10.2 psi

• Turning Radius (outside): 8 ft 6 in

• Length with Standard Bucket: 14 ft 6 in

• Width (with bucket): 6 ft 4 in

• Height to Cab Roof: 7 ft 10 in

• Fuel Tank Capacity: 36 gallons

• Hydraulic System Capacity: 34 gallons

• Auxiliary Hydraulic Flow: 40 gallons per minute

• Hydraulic Operating Pressure: 4,200 psi

• Standard Bucket Capacity: 1.50 cubic yards

• Auxiliary Coupler: Universal quick‑attach

Performance & Design Highlights

• Heavy-Duty Class: 7,000 lb rated capacity and 20,000 lb breakout force for demanding load and lift tasks

• High-Flow Hydraulics: Flow-sharing hydraulics support simultaneous attachments and steering control

• Premium Cabin: ROPS/FOPS-certified with air ride seat, full HVAC, panoramic visibility, and optional rear camera

• High Speed Travel: Two-speed transmission up to 11 mph for quick site transitions

• Attachment Compatibility: Built for forks, grapples, augers, brooms, breakers, and snow implements

Routine Maintenance

• Engine Oil & Filter: Replace every 500 hours

• Hydraulic Fluid & Filter: Change every 1,000 hours; filter every 500 hours

• Fuel Filter: Replace every 500 hours

• Air Filter: Inspect every 250 hours; replace when dusty

• Grease Points: Lubricate loader arms, pivot joints, and coupler daily

• Cooling System: Clean radiator and coolers weekly

• Tire or Track Inspection: Check before each shift for wear and proper inflation

Common Issues & Fixes

• Hydraulic Hose Wear: Inspect daily; replace any showing signs of abrasion or leakage

• Tire or Undercarriage Wear: Monitor tread and integrity—service or replace as needed

• Overheating: Keep cooling fins clear and maintain proper coolant levels

• Electrical or Sensor Alerts: Use onboard diagnostics to inspect connectors, wiring, and fuses

• Reduced Breakout Force: Replace worn bucket teeth and ensure hydraulic filters and fluid are clean