Case SR160 Skid Steer Loader – Parts, Specs

Description:

Serial Number Location

The serial number plate is located on the right-hand side of the loader arm or frame near the front hinge, just below the operator cab. Verify this number before ordering parts to ensure correct fit.

Key Specifications

• Model Years: 2022 – Present

• Engine: 3.9‑L, 4‑cylinder diesel, Tier 4 Final

• Net Power: 110 hp @ 2,400 rpm

• Operating Weight: 13,500 lb (with bucket and full fuel)

• Rated Operating Capacity: 4,150 lb

• Tipping Load: 8,300 lb

• Bucket Breakout Force: 9,800 lb

• Lift Height (to bucket hinge pin): 11 ft 7 in

• Loader Reach at Full Height: 2 ft 6 in

• Travel Speed: Up to 9.5 mph (two-speed)

• Ground Pressure: 6.9 psi

• Turning Radius (outside): 8 ft 4 in

• Length with Standard Bucket: 13 ft

• Width (with bucket): 6 ft 4 in

• Height to Cab Roof: 7 ft 5 in

• Fuel Tank Capacity: 32 gallons

• Hydraulic System Capacity: 28 gallons

• Auxiliary Hydraulic Flow: 32 gallons per minute

• Hydraulic Operating Pressure: 3,600 psi

• Standard Bucket Capacity: 1.05 cubic yards

• Auxiliary Coupler: Universal quick‑attach standard

Performance & Design Highlights

• Heavy-Class Capability: 4,150 lb rated capacity supports demanding lifting and material handling

• Advanced Hydraulics: High-flow, flow-sharing system for simultaneous steering and tool operation

• Comfortable Cab: ROPS/FOPS-certified with air ride seat, HVAC, and rear camera-ready

• Speed & Mobility: Two-speed travel up to 9.5 mph for quick site coverage

• Attachment Versatility: Compatible with forks, grapples, augers, sweepers, and snow attachments

Routine Maintenance

• Engine Oil & Filter: Replace every 500 hours

• Hydraulic Fluid & Filter: Replace every 1,000 hours; filter every 500 hours

• Fuel Filter: Replace every 500 hours

• Air Filter: Inspect every 250 hours; replace as needed

• Grease Points: Daily lubrication on loader arms, pivot joints, and coupler

• Cooling System: Clean radiator and coolers weekly

• Tire or Track Inspection: Check before each use for wear and pressure

Common Issues & Fixes

• Hydraulic Hose Wear: Inspect daily; replace at any sign of damage to maintain efficiency

• Tire or Undercarriage Wear: Monitor tread and integrity—service or replace promptly

• Overheating: Keep cooling components clear of debris and maintain coolant levels

• Electrical Alerts: Use diagnostic readouts to inspect connectors, fuses, or wiring if codes appear

• Reduced Breakout Force: Replace worn bucket teeth and ensure filters and hydraulic fluid are maintained