Bobcat E40 Compact Excavator Specs

Description:

The Bobcat E40 is a compact zero/minimal-tail-swing excavator introduced in 2020, engineered for tight workspaces with powerful performance. It features a non-DPF Bobcat 40.4 hp Tier 4 diesel engine paired with finely tuned hydraulics and a durable slew bearing, delivering strong digging and lifting capabilities. With less than 2″ of tail overhang, the E40 excels in residential, utility, and urban construction environments.

Key Features:

• Engine & Powertrain: 40.4 hp Tier 4 diesel engine, governed at 2,400 rpm; fuel capacity ~13.7 gal

• Digging & Reach: Maximum digging depth ~10.9 ft; reach at ground level ~17.9 ft; bucket force ~7,284 lb; arm force ~4,074 lb

• Hydraulics: Auxiliary flow ~16.9 GPM; system pressure ~2,987 psi; boom swing ~75° left, ~55° right

• Mobility & Frame: Operating weight ~9,180 lb; width ~72.8″; travel speeds ~1.6 mph low, ~3.2 mph high; angle blade optional

Maintenance Essentials:

• Regular hydraulic fluid and filter changes

• Clean dual heat exchangers and radiator to prevent overheating

• Grease boom, dipper, and slew bearings weekly

• Monitor final drive oil condition

Common Wear & Solutions:

• Hydraulic hose or cylinder leaks – replace with seal kits

• Worn pins and bushings – install pin & bushing kits

• Final drive noise/slippage – service final drive components

• Engine rough start/idle – replace fuel and air filters

Serial Number Info:
Serial plate is located on the front of the cab or near the swing bearing. Common prefixes begin with C1FD0… onward. Always verify your serial before ordering parts.

Pro Tips:

• Keep hydraulic seal kits, filters, and grease on-site for efficient repairs

• Use the standard long arm to extend reach by 12″

• Angle blade option gives ±25° adjustment for precise grading